Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

860 Jams at exit, everytime!

Status
Not open for further replies.
Carfoto

Carfoto

Technical User
May 26, 2005
5
US
I have a an 860 that will jam at the exit everytime, has a full page printed, but must pull the paper out, and it feels tight.

Any ideas would be helpful.

Thanks in advance for such an awesome site!

Rick C
 
Sort by date Sort by votes
THE RAPID RELEASE GUIDE IN THESE TEND TO WARP OR DETERIOATE OVER TIME. ITS A FLAT GREEN PLASTIC GUIDE FOUND IN UNDER THE EXIT COVER IT POPS OUT. HAVE A LOOK AT IT, IF IT LOOKS AS IF IT HAS SEEN BETTER DAYS YOU NEED TO REPLACE IT.

MORE ON
SEARCH UNDER EXIT JAMS
 
Upvote 0 Downvote
You need to check the right side at the top of the unit for the solenoid that is behind a small metal plate.
Put tape on the flapper, and reinstall. It will take care of this problem.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

louisbeaumont
  • Locked
  • Question
Xerox colorcube 8700 hang at start up
Replies
0
Views
60
louisbeaumont
louisbeaumont
jsorealty
  • Locked
  • Question
Phaser 7700 fuser jams
Replies
0
Views
34
jsorealty
jsorealty
ltserio
  • Locked
  • Question
Printer hp 8150 doesnt print unless if it is restarted everytime
Replies
6
Views
68
DrB0b
DrB0b
GSBear
  • Locked
  • Question
Phaser 860 - How to remove right cover?
Replies
1
Views
79
TechCowboy
TechCowboy
davidmd1974
  • Locked
  • Question
Phaser 860 Image too low on paper
Replies
0
Views
45
davidmd1974
davidmd1974

Part and Inventory Search

Sponsor

Back
Top