Hi,
I'm just acquiring a "p8200 for parts" from ebay (current unit suspected to have damaged PS or PS Control board, diagnosed based on error codes, results in persistent Xerox logo @ power-up). Originally I had planned to swap out the PS and PS Control board into my current unit. However, the only known problem with the "ebay unit" is the print head needs replacing (persistent stripes on printoutput) and I'm curious, maybe it is easier to change out the print head from the "ebay unit" rather than the PSControl board (from "my old unit" (this PSControlBoard seems to be quite buried internally..)
Any comments about which is the easier route.. or ...are there any postings / info hidden on websites which give hints on either of these procedures .. ?
Any assistance would be *greatly* appreciated.
Thanks!
Tim
I'm just acquiring a "p8200 for parts" from ebay (current unit suspected to have damaged PS or PS Control board, diagnosed based on error codes, results in persistent Xerox logo @ power-up). Originally I had planned to swap out the PS and PS Control board into my current unit. However, the only known problem with the "ebay unit" is the print head needs replacing (persistent stripes on printoutput) and I'm curious, maybe it is easier to change out the print head from the "ebay unit" rather than the PSControl board (from "my old unit" (this PSControlBoard seems to be quite buried internally..)
Any comments about which is the easier route.. or ...are there any postings / info hidden on websites which give hints on either of these procedures .. ?
Any assistance would be *greatly* appreciated.
Thanks!
Tim