6509 E catalyst switch going into a Rommon mode after power down

[Carpua]

Good day

please note that i shutdown my cisco 6509E catalyst switch, and it came back in to a rommom> mode. error "*** System received a Software forced crash ***
signal= 0x17, code= 0x24, context= 0x423586b4
PC = 0x402d248c, Cause = 0x1020, Status Reg = 0x34008002". i tried

rommon 1 > dir bootflash:

Initializing ATA monitor library...
Directory of bootflash:

2 80222724 -rw- s72033-ipservicesk9_wan-mz.122-18.SXF17.bin
9795 265526 -rw- crashinfo_20130816-085431
9828 280328 -rw- crashinfo_20131231-113136
9863 272849 -rw- crashinfo_20131231-115532
9897 257234 -rw- crashinfo_20131231-120310
9929 229160 -rw- crashinfo_20131231-122243
9957 264643 -rw- crashinfo_20131231-131256
9990 251159 -rw- crashinfo_20131231-132419
rommon 2 > set
PS1=rommon ! >
LOG_PREFIX_VERSION=1
SLOTCACHE=cards;
BOOT=bootdisk:,1;
RANDOM_NUM=15004086
TYFIB_BLOCK_ALLOC=
BSI=0
ACL_DENY=1
PF_REDUN_CRASH_COUNT=0
CRASHINFO=crashinfo_FAILED
RET_2_RTS=13:29:37 UTC Tue Dec 31 2013
RET_2_RCALTS=1388496579
?=0
rommon 3 > boot=s72033-ipservicesk9_wan-mz.122-18.SXF17.bin
rommon 4 > sync
rommon 5 > set
PS1=rommon ! >
LOG_PREFIX_VERSION=1
SLOTCACHE=cards;
BOOT=bootdisk:,1;
RANDOM_NUM=15004086
TYFIB_BLOCK_ALLOC=
BSI=0
ACL_DENY=1
PF_REDUN_CRASH_COUNT=0
CRASHINFO=crashinfo_FAILED
RET_2_RTS=13:29:37 UTC Tue Dec 31 2013
RET_2_RCALTS=1388496579
boot=s72033-ipservicesk9_wan-mz.122-18.SXF17.bin
?=0
rommon 6 > confreg 2102


You must reset or power cycle for new config to take effect
rommon 7 > reset

But still no luck please help.

 

[vipergg]

What do you have for a boot statement ?

 

[m4rc00]

Maybe Output Interpreter will help to check crash ouputs ->

https://www.cisco.com/cgi-bin/Support/OutputInterpreter/home.pl?locale=en

(login required).

In the crash outputs should be more information what was the cause. Also good idea is an upgarde your IOS as is almost ancient