6.0 MICS to MICS

[nortechie]

Has anyone found how to:
1) Transfer calls between 2X MICS 6.0 w/ Cent.VM(4.1)
2) Call Park ???
3) Call Pick-up
4) Paging

and does the MICS 6.1 fix any of these problems?
also are there other issues that maybe I have not ran into yet!

Tahnks

 

[hawks]

I think you need to be running a PRI between the 2 with the SL1 protocal.

 

[nortechie]

Hawks, I am Running a Private SL-1 Network over PRI + a Public Network on Both systems using PRI, I can Intercom seamlessly, I can call via the PRI's and Loop Trunks on both sides and access all trunks from each other ... Sys A can access the PRI + Loops on Sys B and vice versa. But I can not trasfer, park or page Between systems. The centalized VM works Fine.

Does anyone know when and why you should use:
ICCL
TRO
TAT
NCRI
and will any of these help

 

[salo0920]

Nortechie,

How do you Intercom seamlessly? When I do this, I cannot get the other side to look like an internal call. The ring pattern is that of a trunk call rather than a station call, know what I mean???

 

[nortechie]

salo0920, I know what you mean, I just have not noticed, I guess its because on the systems that I have this app. Both sides have their own lines (PRI-DID) and the target line rings and appears on the sets, so external calls ring in on the target line button and internal calls ring in on the intercom because they are set up as ring only (each set is set up with 2 target lines 1-External DID[over public PRI] 2-Internal DN [over private SL-1 PRI].
On Aug.1st I have to install 4 sytems together and each location is almost maxed out (80-120sets), so I will not be able to give them 2 target lines each...so I am trying to figure out the digit pattern for each site and make shore that there are no conflicts and that the Internal and External Rec'd digits match so that they only require 1 targ. line.