576HD delayed ringing

[Cnez]

Whats up everybody, I am a Toshiba/Nortel tech with limited experience with Panasonics years ago.

Situation is we took care of a customers Panasonic 576, was able to keep them happy as they only needed simple changes. Customer has since moved to a new location. What they did though is sold the Panasonic to the new tenant and told them we could take care of the service. New customer wanted a bit more than simple changes. I have been able to get everything setup so far for them using the manual.

The only issue im having is setting a delayed ringing. They want 3 phones to ring immediate and the rest to ring on a delay. I know this has got to be super easy. Everything I have tried as far as the manual goes seems to either do nothing or make the phones not ring at all. If I could just get some direction on where to look that would be awesome.

 

[obtsystems]

It is years since I worked on one of these, but from what I remember you can set it up like below



Day1 Delayed Ring Destination
(all CPCs) - Version 1.0 or higher
Assign a destination extension, Hunt Group, SSD code, or Attendant Hunt Group,
depending on the setting in the above address.
FF2 1 BSSC 05 1 Hold (0-9999) Hold
BSSC: ISDN Trunk Position
B=Cabinet no. 1-6
SS=Slot no. 01-12
C=Circuit no. 1-4 (BRI)
or 1 (PRI)
Destination Number:
(if “1=delay-ring to Extension”)
default: [no assignment]
(if “2=delay-ring to Hunt Group”)
(if “3=delay-ring to SSD”)
Ext.No., Virtual Ext.No., or Closed No.
(if “4=delay-ring to Attendant”)
Extension Hunt Group No. (1-72)
SSD Code No.
Attendant Hunt Group Pilot No.

 

[Cnez]

Excellent! I should be able to get over there tomorrow and test this out. Thank you very much.