5550 Console resiliency Day/Night1/Night2 services

[mitanjo]

Hello,

One of my customer has an installation with two ICPs on IP Networking/Cluster aso in resiliency.

One 5550 console is installed on the primary ICP. If the primary ICP fail down, then everything "move" to secondary ICP via resiliency.

If for example, the 5550 console was in Night2 service, before primary ICP fail down, when connection on primary ICP becomes OK and 5550 console status changes to Day service then the secondary ICP stays on Night2 service.

We would like that when we select a Day/Night1/Night services on the 5550 console, which is on primary ICP, we also change the status on the secondary ICP.

Please, do you know how can I configure this?

 

[kwbMitel]

There is no way to do it in one step. Each system needs to be set into night separately.

2 Options:

Have a set near the console that runs off the resilient system. Set night mode on the resilient system via Dialed Night Service.

Set up DISA access to the resilient system. Access system via DISA (from Console) and use Dialed Night Service

*******************************************************
Occam's Razor - All things being equal, the simplest solution is the right one.

 

[mitanjo]

OK so for you there is no other way...

Thanks for your help!