500v2 with 2 DS30 - Second expansion isn't recognized

[Schaef87]

v10.0.0.3 build 5

Plugged the expansions in ports 1 and 2, also named as such, and only the first DS30 was recognized by the control unit.

I tried restarting the whole system, plugging in the DS30's first, waiting for flashing green, then the control unit; but the same thing happens.

I tried taking out the known good DS30 and just leaving the other, and it's not recognized, and just blinks green.

I tried a format/recreate of the SD card but same results.

Is there a way to force that DS30 to do anything else?

Programming should make you feel like god. But it doesn't because there are rules.

 

[Schaef87]

After trying different expansion ports, swapping the blue cables, and following this

http://www.wellingtonpaez.com/dead-ds30/

I am concluding that this unit is probably dead.

When it goes to access the .bin on the tftp server, it just keeps sending requests, but nothing is hitting the server. The control unit can pull files, but not the DS30.

Programming should make you feel like god. But it doesn't because there are rules.

 

[janni78]

What firmware version was the DS30 on?
Do you see it when you look in "Upgrade"?

"Trying is the first step to failure..." - Homer