Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

450 Baystack lost it's stack config.

Status
Not open for further replies.
ECastro

ECastro

IS-IT--Management
May 1, 2002
5
0
0
US
I was upgrading the boot code and switch agent. After I did the upgrade, the firmware on my base unit was upgraded buthe rest weren't(5-stack). Now, it sees the base switch in switch mode not stack mode. What can I do?
 
Sort by date Sort by votes
Cross over cable (and serial cable) to each Switch set an IP address and syncronize the Firmware then reboot all of them to get it to be a Stack again I tried to remain child-like, all I acheived was childish.
 
Upvote 0 Downvote
Thanks Jim. That did the Trick!!!

Ed
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

CalebNT
  • Question
4526GTX-PWR/4500 Series Firmware
Replies
1
Views
375
dialtonebone
dialtonebone
G450
  • Locked
  • Question
BCM 450 not dialing local 10 digit number on a PRI
Replies
0
Views
50
G450
G450
Billycee
  • Locked
  • Question
Nortel 5520 switch stack issues
Replies
1
Views
80
bdk76
bdk76
AlfonsoSF
  • Locked
  • Question
how to configure a port with two or more vlans
Replies
0
Views
97
AlfonsoSF
AlfonsoSF
NetEngBB
  • Locked
  • Question
Avaya UC Module v11.1 on IP Office 11.1 issue saving/backup configuration
Replies
1
Views
53
ipohead
ipohead

Part and Inventory Search

Sponsor

Back
Top