I was upgrading the boot code and switch agent. After I did the upgrade, the firmware on my base unit was upgraded buthe rest weren't(5-stack). Now, it sees the base switch in switch mode not stack mode. What can I do?
Cross over cable (and serial cable) to each Switch set an IP address and syncronize the Firmware then reboot all of them to get it to be a Stack again I tried to remain child-like, all I acheived was childish.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.