Then you better lock the ports
I think you can do that on the IPO but you need to DTE in to the unit.
I never tried to change it so it will be on your own risk
If I lock them on the cisco switch it's usually enough. What threw me is that the last one I installed was a 412 which I researched as being half duplex. I just installed a 406 and assumed it was the same. Threw me a curve.
Weird, Port 8, configured as VLAN2 will not come up as 100 full even though port 1 does. And I'm getting collisions that seem to suggest it only supports half duplex.
Note: Once LAN2 has been enabled on the system erasing the configuration back to
factory default will not remove the LAN2 setting. When the setting is enabled it is
written to FLASH so that the Ethernet switch is programmed before the main IP
Office code is loaded. When the IP Office configuration is erased the system restarts,
reads the setting in FLASH and then sets up a LAN2 port in the default configuration.
If you want to remove the LAN2 setting from a defaulted configuration you should untick
the ‘Use Port 8 as LAN2’ checkbox, save the configuration, restart the IP Office
and then default the configuration.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.