Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

4 Digit Dialing Between Locations

Status
Not open for further replies.

ParaGuy

IS-IT--Management
Oct 14, 2015
10
US
thread851-1756339


I am still having this problem. I have learned quite a bit more about how the call manager works but I still do not have a solution as to why I do not have 4 digit dialing between remote locations. I am using the SIP SCCP profile on these phones. I am using Cisco Call Manager version 8.0.3. I have also drawn a diagram showing the problem I am having.
I was told by another individual that the VPN between the locations may be causing the half duplex calling problem but it is a standard BOVPN through WatchGuard. I don't understand how this would be causing a half duplex problem.
 
 http://files.engineering.com/getfile.aspx?folder=06763fa8-7c54-4605-8b87-368f2559ab34&file=Call_Manager_Problem_Diag_1.pdf
With most IP telephony solutions once the call is setup, the media (ie Audio) bypasses the phone systems and travel directly between the two endpoints.

For this to work the network needs to know how to route between the two end points. If you have a NAT configuration then you will need to configure the router or firewall to be able to pass the traffic to the right endpoints.

One way speech often suggests one side cant route to the other.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top