Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

4.1 R1 NVRAM to a new MICS 032 with XC 7.0 R2 NVRAM.

Status
Not open for further replies.

peck4

Vendor
Jul 20, 2007
28
US
Overview

Need to replace an existing MICS 032 with XC 4.1 R1 NVRAM to a new MICS 032 with XC 7.0 R2 NVRAM.

I have a new 032 KSU, XC 7.0 software and R2 NVRAM. I also have a new PRI Key Code and the USA XC Upgrade Tool.

My game plan

With a RAD, back up existing 4.1 to my laptop
Power down the existing 032 and pull out the 4.1 software
Install the existing 4.1 in the new 032 with a new R2 NVRAM
With a RAD, restore the customer data to the new KSU
Use the upgrade tool to get 4.1 to 7.0

Please help me with the following questions

At what point do I install the new PRI key code in the new 032, before or after the restore

Should I restore the new 032 with all the station modules attached, before the upgrade

Can I put the original 4.1 back in the existing 032 and go back to the original configuration, or will I have a new System Id problem

Thank you for your help


 
I would not even activate the PRI code until the upgrade is completeted and tested.

but other than that you look to be on the right track.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top