Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

3rd PRI on 6.1 software 2

Status
Not open for further replies.

DDKo

Technical User
Oct 22, 2007
1
CA
Can you put 3 PRI's on a Meridian Norstar Modular ICS 6.1 Software? The third card in mod 8 is programmed as a PRI Card, but is coming up as 24 loops and should only be one, do you have any ideas?
 
You already have at least one PRI in the system or are they straight T1? Mod 8, should start with line 61 for the thrid T1/Pri
 
You need to program Mod 8 to be a PRI. You can only have the DTM card in that MOD and you need to disable it b4 making the change.
 
When he says the third card in mod 8 he means the 3rd PRI card is in mod 8 and is alone.
The card is programmed already as a PRI and does start at line 61 but shows as 24 loops.
Documentation does not seem to give any info or speak of a 3rd PRI.
Why would it show 24 loops?.
Is there trickry to get a 3rd going?

Maybe some PRI guru's can direct as how to set 3 PRI's up?

Thanks


 
Are we sure he is saying PRI Or is It just T1
techs say t1 for t1 pri for pri
wanna be's say pri for t1 and pri
 
I think I remember reading something about the DTI card needs to be a certain release (like four A's at he end of the part number).
 
No problem.
And yes he is a friend, past co-worker and pain in the ass.

Turns out he had latest version card but to get it to show 1 loop was having to go into Line Trunk programming and telling it to be PRI C.

Maybe if it was MR software it may have done this for him auotmaticaly?....never done 3 of them so new to me too.

Thanks for fast response.




 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top