3com 4500

[wayneo4528]

Good day.

I'm trying to setup a 3Com 4500 switch to work with 2 Vlans. The IP 500 V2 is up and running with 1608's. I need to know what the config would be to get this to work. All hardware is on the lastest firmware releases.

Regards

Wayne

 

[tlpeter]

There is nothing you can do in the ipoffice for that.
You need to configure vlans on the switch.


BAZINGA!

I'm not insane, my mother had me tested!

 

[wayneo4528]

Hi

I know. I need help with the setup of the 3Com switch?

 

[kholladay]

Might have better luck in the HP/3COM forum

http://www.tek-tips.com/threadminder.cfm?pid=545

Kyle Holladay
ACSS & APSS SME Communications
MCP/MCTS Exchange 2007
Adtran ATSA, Aruba ACMA

"Thinking is the hardest work there is, which is the probable reason why so few engage in it." - Henry Ford

 

[tlpeter]

Then i think you need this doc:

http://support.3com.com/infodeli/tools/switches/4500/3Com_Switch_4500_Quick_Reference_Guide.pdf

BAZINGA!

I'm not insane, my mother had me tested!

 

[TheProvider]

If you are using the same port for Phones and data you need to configure switchport mode hybrid on the 4500, it is the equivalent to the cisco voice vlan

 

[TheProvider]

An example

You will need to do this in sys mode.

interface Ethernet1/0/1
poe enable
stp edged-port enable (Otherwise your port will take a while to come up)
port link-type hybrid
port hybrid vlan X tagged (Your Voice VLAN)
port hybrid vlan 1 untagged (Your Native VLAN)

 

[wayneo4528]

Thank you very much TheProvider.