3904 set has an "L" before the dn

[citypbxman]

I had programmed a remote 3904 working on a 9150 gateway for key 5 scr xxxxx. The set did not change and the programmed key will not ring. I went to the set and key 5 display reads Lxxxxx. Any input?

 

[KCFLHRC]

Everything else works on the set? You just added key 5 scr xxxx and it doesn't work, correct?

 

[KCFLHRC]

I think I remember this issue now. The "L" means that key is configured for a local calling key. On the 9150 you could plug in a local POTS line and have it appear on the digital set. You may have to go into Configuration Manager to remove that feature.

 

[KCFLHRC]

In the 9150 Port Configuration Screen, click on configure for that port. Then it will open up a new window and you will see at the bottom where the local call keys are configured.

 

[citypbxman]

Thank You. This is enough direction to correct this .