3640 router configuration problem

[XTC007]

Hi all,

i have surfed on google and many forum 1 week ago to find my solution without success...

i'm a newbie with cisco router.

i have a linksys RV016 where my cable modem with static ip are plugged in my wan and he provide the internet on my 3560 switch

i have buy a 3640 router with a NW-2E2W to build a strong cisco network and my problem are started here (i also have a magnum TP1 AUI i'm not sure what it's do)

i have configured the ethernet 0/0 with my isp static ip
and the ethernet 0/1 with my lan ip

i have removed the rv016 to install this one anything doesn't work else i can log to my router via

http://my.isp.ip

but i can ping at all

and tried to configure route without success, it return error and when no error it not work anymore.

do i miss a configuration? or hardware missing in w0 or w1

Anyone have few minute to tell me what's wrong...
my router can do the job why i have buy it?
Or i have buy the wrong router for my use?

Thanks, i will really appreciate your reply

Ray

 

[CiscoGuy33]

Ray,

Post a show run, so we can see your running config on this router to help you.

E.A. Broda
CCNA, CCDA, CCAI, Network +

 

[XTC007]

Hi CiscoGuy33,

there's the show run return

Building configuration...

Current configuration : 748 bytes
!
version 12.2
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname RTR01.XXXXXXXXX
!
enable secret 5 ***********
enable password ***********
!
memory-size iomem 15
ip subnet-zero
!
!
!
!
!
!
interface Ethernet0/0
ip address 69.70.XX.XX 255.255.255.248
no ip mroute-cache
half-duplex
no cdp enable
!
interface Ethernet0/1
ip address 10.100.0.1 255.255.255.0
no ip mroute-cache
half-duplex
no cdp enable
!
router rip
redistribute connected
network 10.0.0.0
network 69.0.0.0
!
ip classless
ip http server
!
dialer-list 1 protocol ip permit
dialer-list 1 protocol ipx permit
!
line con 0
exec-timeout 0 0
line aux 0
line vty 0 4
password ***********
login
!
end


the 69.70.XX.XX are my static ip from my isp
the 10.100.0.1 are my local network

Thank you

Ray

 

[VinceWhirlwind]

How does your cable modem actually create an active link to your ISP?
Does it not have to authenticate with your ISP in some way - eg PPOE/A or something?

 

[XTC007]

i have my cable modem (always online no auth required)
the authentification are made by my isp with the mac adress of the modem

i have static ip on this cable modem, i habitually just
configure my router like my linksys RV016 with static wan ip
i provide the ip, subnet and gateway and i'm online.