Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

3.8 installation on SunFire V120

Status
Not open for further replies.
01backuper

01backuper

IS-IT--Management
Jan 2, 2006
27
A2
Hi y'all,

I have attempted to install the OpenBSD version 3.8 for Sparc 64 on my SunFire V120, and although it seems that no problems appeared during the installation, on boot, i reach a point where the system seems to halt, without any noticeable errors. It goes through a sort of diagnostic sequence (just like the cd does) and then it halts..
Any suggestions?

Thanks
 
Sort by date Sort by votes
Hey folks, i got this all figured out on my own..
In case anyone else gets into the same trouble, try removing the CDROM drive from your V120 after installation of 3.8. Mine booted just fine afterwards.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

bhuv560
  • Locked
  • Question
Postfix Installation on EC2 AWS Linux
Replies
0
Views
144
bhuv560
bhuv560
msk69
  • Locked
  • Question
RHEL 7 installation error
Replies
1
Views
223
msk69
msk69
SamBones
  • Locked
  • Question
Linux 7 Installation Failures 1
Replies
3
Views
209
SamBones
SamBones
gregor weertman
  • Locked
  • Question
set samba "template shell" dependent on group
Replies
0
Views
133
gregor weertman
gregor weertman
lslamp
  • Locked
  • Question
Bash Onliner ... 1
Replies
2
Views
246
lslamp
lslamp

Part and Inventory Search

Sponsor

Back
Top