3.8 installation on SunFire V120

[01backuper]

Hi y'all,

I have attempted to install the OpenBSD version 3.8 for Sparc 64 on my SunFire V120, and although it seems that no problems appeared during the installation, on boot, i reach a point where the system seems to halt, without any noticeable errors. It goes through a sort of diagnostic sequence (just like the cd does) and then it halts..
Any suggestions?

Thanks

 

[01backuper]

Hey folks, i got this all figured out on my own..
In case anyone else gets into the same trouble, try removing the CDROM drive from your V120 after installation of 3.8. Mine booted just fine afterwards.