We have a T-1 coming into a Cisco 2620 router, which goes to a PIX 515. we have a block of 30 IPs and are only using about 6 of them now.
We want to setup a FTP server and a few other things, but keep it seperate from our network. So the firm that we outsource alot of our networking to, ordered an ethernet card for our PIX. They came to install it this morning, but couldn't figure out how to create a second network using one of the public IPs we have open.
When we changed the subnet of our primary network from 224 to 240, it let us setup the IP scheme for the new card and a computer hooked to it sees it just fine. However, we cannot get to anything outside the firewall.
Can anyone help? Is there something that needs to be changed on the Router? (when changing the subnet to 240, is the router not sending anything to the IPs outside of that subnet?) Is there something we need to do on the PIX?
Any help would be great!
Thanks
We want to setup a FTP server and a few other things, but keep it seperate from our network. So the firm that we outsource alot of our networking to, ordered an ethernet card for our PIX. They came to install it this morning, but couldn't figure out how to create a second network using one of the public IPs we have open.
When we changed the subnet of our primary network from 224 to 240, it let us setup the IP scheme for the new card and a computer hooked to it sees it just fine. However, we cannot get to anything outside the firewall.
Can anyone help? Is there something that needs to be changed on the Router? (when changing the subnet to 240, is the router not sending anything to the IPs outside of that subnet?) Is there something we need to do on the PIX?
Any help would be great!
Thanks