Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

2811 FXS FXO dial-peer, plar, voice hunt-group...

Status
Not open for further replies.

LCIS

Technical User
Oct 9, 2005
35
CA
I have a 2811 (CME) with 4xFXO, 2xFXS, 7941 (ip phone).

1- I would like to be able to receive a call from outside and that both phone will ring in same time (7941 and analog).
2- I would like to be able to call outside from any phone.
3- I would like to be able to call my analog from my voip and my voip from my analog.

The line goes from the phone compagny to my FXO (0/3/0) and from my FXS (0/2/0) to all my analog phones.

Let say that my analog phone number is: 123-456-7890 and my Voip is 4000.
Thanks for your time !!!

LCIS TECH
LAND COMMUNICATION INFORMATION SYSTEM
DND
 
Hello

Can you please post your present conf.Below is the conf to help you receive inbound calls and make outbound calls with the analog phone.

Conf for FXO port :

Voice-port x/x/x
Signal loopstart
Dial-type dtmf
Cptone US = your country
Connection plar opx 101 = number of choice
Caller-id enable

Dial peer for inbound calls

dial-peer voice 1 pots
destination-pattern .T
port x/x/x = above already configured/Telco line

Conf for FXS port:

Voice-port x/x/x
Cptone US = your country
Caller-id enable

Dial peer for outbound calls

dial-peer voice 2 pots
destination-pattern 101 = this is your inside number of you analog phone ,must ne the same as the “PLAR”
port x/x/x = FXS port where the analog phone is connected

What you want to do is a bit involve ,so it’s best to go step by step.

Regards
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top