2610 error... 1

[FredUG]

Our 2610 started spewing this error over and over, I assume my ethernet interface is going bad but I've found nothing on this error while searching.

2d14h: %AMDP2_FE-5-LATECOLL: Ethernet0/0 transmit error
2d14h: %AMDP2_FE-5-LATECOLL: Ethernet0/0 transmit error

Any ideas?

TIA,

FredUG

 

[eurobadger]

Hi FredUG.

I got this from Cisco's output analysis tool



%AMDP2_FE-5-LATECOLL (x1): [chars], transmit error

Explanation: Late collisions occurred on the Ethernet or Fast Ethernet interface.

Recommended Action: If the interface is Fast Ethernet, verify that both peers
are in the same duplex mode. For regular Ethernet, the system should recover. No
action is required.--------------------------------------------------------------------------------
%AMDP2_FE-5-LATECOLL (x0): AMDP2/FE [chars], Late collision

Explanation: Late collisions have occurred on the Ethernet or Fast Ethernet interface.

Recommended Action: If the interface is Fast Ethernet, verify that both peers
are in the same duplex mode. If the interface is Ethernet, the system should recover.
No action is required

It looks like you have a device on the interface where the duplex setting does not match. It may be a device that cannot negiotiate with a Cisco box, and if so you will have to fix the duplex setting on both ends of the link manually.

EB

 

[NMCman]

The router here is acting as a reporting device. There are late collisions on the network, not necessarily on the routers interface.

I have seen this before where there is a routing loop. Check the CPU utilisation.

 

[FredUG]

Thanks guys, I'll check the negotiation setting on the router and the PIX-506e (The "other" end of the eth0/0 int) to make sure they match then move on to inspecting switches and NICS.

FredUG