2610 and External CSU

[bdssbrd]

We had a split T-1 installed. I am using a TSU 120 to split the line, and the voice is going to my phone switch and the data is going to my Cisco 2610.I am having a problem getting my 2610 to stay up. My line protocol is down. I think it has something to do with the clocking settings???? However, I don't see anything to change.

Any ideas???

Thanks,

Rick

 

[gconnect]

what serial encapsulation are you running (PPP, frame, etc)

post the output from you 'show interface' command
and also your config so that we can see how you clock source stuff is set up.

is your tsu configured correctly?

 

[bdssbrd]

I just looked at my CSU, and it was set for 56k, instead of 64k. I changed that and theinterface came right up.