2400 IMX 1

[wayne50]

What is the procedure for installing a new 16ELCJ card , we are using 16ELCJ-B cards in all 4 Pimms. When I plug in the 16ELCJ card no lights come on. Any help is appreciated.

 

[VDG]

That's Normal.

When the first LEN on that card is assigned the OPE lamp will light and the other 15 line status lamps will flash.

As an aside, by first LEN I mean any one of the 16 not the bottom LEN.

Victor

 

[wayne50]

I tried this but still nothing. Is their any programming or dip switch settings that needs to be done on the card, Thanks.

 

[CDRMAN]

Make sure the toggle switch is down ,

Only switch to watch for is SW01 POS 7 IF USING IN 16 ELC MODE HAVE IT ON
Normally 1-7 are on 8 is not used

What slot is your card and and waht LENS did you program the phone in

 

[wayne50]

MB toggle is down and sw01 , 1 is off because we use APA's
and the rest are on. I used lens 011031 for a test and it did not work. Thanks

 

[CDRMAN]

Ok pardon me if I ask a few dumb questions

The Lens is 011031 So your card should be in PIM1 slot 5

Check to make sure there is nothing else programmed in lens 011020-011037 like tec 18s etc.

I would try to add a tec 12 in 011020 that should be the first port on the card.

Try turning on SW01 Pos 1 just to see if the card comes up

Do you get any errors when programming the phone ?

Can you put another dterm card in that you know is good into that slot to see if it comes up?

 

[wayne50]

Thanks for the help, it works just fine.

 

[gbaughma]

wayne50:

I thanked him for you.



Just my 2¢

"In order to start solving a problem, one must first identify its owner." --Me
--Greg

http://parallel.tzo.com