Hello
I have a Windows 2003 domain running in 2003 functional mode.
I just deployed a member server to another location on a different subnet. NOTE SAME ACTIVE DIRETORY SITE but different subnet.
The server is a file and print server for that location, and also serves as the DHCP server for that location.
I configured the server at HQ, which has network address 192.168.1.0. During configuration, I let the server pick up a dynamic IP (which was 192.168.1.43). During this configuration, I Configured the DHCP server component to have a small scope on the HQ subnet. After testing, I disconnected the server from the network, deleted the test DHCP scope, set the server to have a static IP of 192.168.2.200 for its new subnet of 192.168.2.0.
When the server was hooked up to the network at the new location I was unable to connect by name. It turns out my DNS servers at HQ are showing the server's address as 192.168.1.43.
I've tried the following:
Deleting the A record from the DNS Server and then running ipconfig /registerdns on the remote server. This works - the address is updated to the correct 192.168.2.200 - but it goes back to 192.168.1.43 within a few minutes.
I also tried running ipconfig /flushdns on the DNS server, then repeating the above procedure. However, the same result happens.
Any help will be greatly appreciated.
I have a Windows 2003 domain running in 2003 functional mode.
I just deployed a member server to another location on a different subnet. NOTE SAME ACTIVE DIRETORY SITE but different subnet.
The server is a file and print server for that location, and also serves as the DHCP server for that location.
I configured the server at HQ, which has network address 192.168.1.0. During configuration, I let the server pick up a dynamic IP (which was 192.168.1.43). During this configuration, I Configured the DHCP server component to have a small scope on the HQ subnet. After testing, I disconnected the server from the network, deleted the test DHCP scope, set the server to have a static IP of 192.168.2.200 for its new subnet of 192.168.2.0.
When the server was hooked up to the network at the new location I was unable to connect by name. It turns out my DNS servers at HQ are showing the server's address as 192.168.1.43.
I've tried the following:
Deleting the A record from the DNS Server and then running ipconfig /registerdns on the remote server. This works - the address is updated to the correct 192.168.2.200 - but it goes back to 192.168.1.43 within a few minutes.
I also tried running ipconfig /flushdns on the DNS server, then repeating the above procedure. However, the same result happens.
Any help will be greatly appreciated.