Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

2 T1's

Status
Not open for further replies.

kg00se

IS-IT--Management
Mar 2, 2006
56
US
I have 2 T1's coming into my router and I want to make sure that the packets coming in are being distributed evenly across both T1's is there an easy show command that would show this information?

thanks
kg00se
 
It depends where the routes are coming from cause they will try to used the fasted path unless ur manipulation those paths...

tel more about ur conf pls
 
just looking for a percentage of usage across the 2 wic cards
 
by default it wull usually be doing per destination load balancing assuming things are equal...

you can always do a sh int s0/0 and sh int s0/1 to compare utilization at any give time..
look for the input and output throughputs.

you may want to do a load interval 30 on them to get 30 second averages instead of the default 5 min values.
 
that will give me what I am looking for

thanks
 
ip load-sharing per packet set on both routers will work.

EIGRP equal cost load balance should work.

You can also use multilink PPP to bind the serial interfaces.

You have a lot of options choose what best suites your application.

“Reserve your right to think, for even to think wrongly is better than not to think at all”

CCNA,CCNP,Network+
Tek-TIP Member 19,650
[americanflag]
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top