steinkebunch
Programmer
I created two cursors from remote data, and would like to populate comboboxes on my form with these cursors. I can see both cursors in the Datasession window, but according to VFP help, these cursors are not opened in the work area.
The rowsource of of each comboboxes reads as follows:
Combobox1:
Combobox2:
When running the form, one combobox populates fine, the other generates a "Cannot access the selected table" error. Is it that VFP does not see the second cursor? I tried adding a
or
statement to each comboboxes init method. That did not help.
Any suggestions? Thanks in advance.
The rowsource of of each comboboxes reads as follows:
Combobox1:
Code:
select * from cursor1
Combobox2:
Code:
select * from cursor2
When running the form, one combobox populates fine, the other generates a "Cannot access the selected table" error. Is it that VFP does not see the second cursor? I tried adding a
Code:
select cursor1
Code:
select cursor2
Any suggestions? Thanks in advance.