Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

2 Public IP Addresses

Status
Not open for further replies.

CBack85

IS-IT--Management
Jun 6, 2007
289
US
Is there a way to get 2 Public IP Addresses on a TZ 190?

I can't figure it out. I only see a spot for one address.
 
Need a little more info.

Do you have two different ISPs?

What is your subnetmask for the Pubic IP range?

Is your ISP giving you two public IP ranges on different subnets?
 
If what you are trying to do is setup another static ip in the same network for the purposes of port forwarding. Then all you have to do is create the port forwarding rule as you normally would and apply the secondary address to the rule. I ran into this same thing and beat my against the wall for little bit. After some research I found that there isn't actually a place to assign the secondary Ip address. You just create your necessary firewall rules and use the secondary ip address that you want to use for those rules.

Network+
Inet+
MCP
MCSA 2003
MCTS
 
Yep got it figured out with the firewall issue! also had to do a one to one NAT
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top