2 location and outbound calls

[dmouge]

Hi,

I have a s8700 on 1 site with 2 G650 on site A and a remote gateway G650 on site B the link between the 2 sites will be on the first step a small link so i do not want the people on site A to used the trunk on site B and vice versa. I was thinking about partitioning table but i'm wondering if there is no other way to handle that.

 

[TykeUK]

I had the same setup and other than tennant partitioning, partition route tables are in my opinion by far the easiest/quickest to setup and use.

 

[Technician101]

Let up each of the sites with their own location codes and assign the location codes on the gateway config screen.

After this is done then you can build a separate ARS pattern for each location by using:

Change ARS analysis location x (plus a digit qualifier)

ie: ch ars ana loc 2 1 (to change 1+dialing)

Hope this helps.

 

[dmouge]

looks like pretty smart idea. I will do a test with this. thanks

David