Hey guys - so i am trying to configure a second Avaya IP500V2 for resiliency to our Primary IP500V2. At this point i have the SCN up and the IP office lines between the sites created / and am just trying to get IP phones to rollover properly. The question i have for now is - when selecting the "SCN Resiliency Options" on the IP Office Line / do i enable/check them on the Primary IP Office's SCN Line, the Resilient IP500V2's IP Office Line, or on both systems scn lines?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
2 - IP500V2 11.0.4.6 setup for Primary & Secondary (Resiliency)
- Thread starter rgunther
- Start date
You can do it on both even if it is only needed on the primary in your case. You need to setup valid SIP FQDNs on both and a common SIP domain.
J-Series phones have to pull the 46xxsettings.txt newly to learn the second call server.
IP Office remote service
IP Office certificate check
CLI based call blocking
SCN fallback over PSTN
J-Series phones have to pull the 46xxsettings.txt newly to learn the second call server.
IP Office remote service
IP Office certificate check
CLI based call blocking
SCN fallback over PSTN
- Status
Similar threads
