It would not hurt to try it. Console are serial port and serial port are 9 pin on the computers so it almost make sense. You would use that to configure your Switch.
"To connect a PC terminal to the console port, use the RJ-45-to-RJ-45 roll-over cable and either the RJ-45-to-DB-25 female DTE adapter or the RJ-45-to-DB-9 female DTE adapter" quote Route once; switch many
For a 1900 swich with a DB9 console connector you must use a null modem cable. Using a roll-over and two RJ45 - DB9 adapters does not work - although you can still display the diags. console with this set up you can't get the management console.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.