any way to restore service to a 0x16ttr cp that in
maintenance says...."no fw"
get ndt and attempting to busy out, restore and reset don't
get any responce.
In the last day or two, I have had several calls similar to this concerning many different types of modules.
I am certain that there were MULTIPLE power hits in many parts of the country.
That being said, you can do the following:
1 - Power down and back up
2 - In maintenance do a BUSY OUT & RESTORE
3 - In System Programming, do a BOARD RENUMBER
IF none of the above give relief, try powering down, remove the failing card and power up, do the board renum without it - then power down again - put it back and power up again and do another board renumber.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.