I have tried two seperate 1601 routers and two seperate WIC-1DSU-56k cards. I still get bad interface. Here is the boot log. Any ideas appreciated. Thanks
System Bootstrap, Version 11.1(7)AX [kuong (7)AX], EARLY DEPLOYMENT RELEASE SOFTWARE (fc2)
Copyright (c) 1994-1996 by cisco Systems, Inc.
Simm with parity detected, ignoring onboard DRAM
C1600 processor with 4096 Kbytes of main memory
program load complete, entry point: 0x4018060, size: 0x1da950
%C1600-4-BADINTFC: Interface 2, (0-1 Onboard interfaces 2=WIC)
Invalid interface (Unknown, Uninitialized or Bad Cookie value read)
%C1600-4-INTFCNOFLH: Unable to load images or communicate over interface
%QUICC_ETHER-1-LOSTCARR: Unit 0, lost carrier. Transceiver problem?
%SYS-4-CONFIG_NEWER: Configurations from version 12.2 may not be correctly under
stood.program load complete, entry point: 0x8000060, size: 0x711630
Restricted Rights
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco Internetwork Operating System Software
IOS (tm) 1600 Software (C1600-Y-L), Version 12.2(
Copyright (c) 1986-2003 by cisco Systems, Inc.
Compiled Thu 19-Jun-03 10:12 by pwade
Image text-base: 0x0803C1B4, data-base: 0x02005000
cisco 1601 (68360) processor (revision C) with 3584K/512K bytes of memory.
Processor board ID 05574641, with hardware revision 00000000
Bridging software.
X.25 software, Version 3.0.0.
1 Ethernet/IEEE 802.3 interface(s)
1 Serial network interface(s)
1 Serial(sync/async) network interface(s)
WIC with 56k 4-wire CSU/DSU
System/IO memory with parity enabled 4096K bytes of DRAM on S
ry disabled)
System running from FLASH
7K bytes of non-volatile configuration memory.
8192K bytes of processor board PCMCIA flash (Read ONLY)
% WARNING - 64k mode will not work in back-to-back DDS.
Press RETURN to get started!
System Bootstrap, Version 11.1(7)AX [kuong (7)AX], EARLY DEPLOYMENT RELEASE SOFTWARE (fc2)
Copyright (c) 1994-1996 by cisco Systems, Inc.
Simm with parity detected, ignoring onboard DRAM
C1600 processor with 4096 Kbytes of main memory
program load complete, entry point: 0x4018060, size: 0x1da950
%C1600-4-BADINTFC: Interface 2, (0-1 Onboard interfaces 2=WIC)
Invalid interface (Unknown, Uninitialized or Bad Cookie value read)
%C1600-4-INTFCNOFLH: Unable to load images or communicate over interface
%QUICC_ETHER-1-LOSTCARR: Unit 0, lost carrier. Transceiver problem?
%SYS-4-CONFIG_NEWER: Configurations from version 12.2 may not be correctly under
stood.program load complete, entry point: 0x8000060, size: 0x711630
Restricted Rights
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco Internetwork Operating System Software
IOS (tm) 1600 Software (C1600-Y-L), Version 12.2(
Copyright (c) 1986-2003 by cisco Systems, Inc.
Compiled Thu 19-Jun-03 10:12 by pwade
Image text-base: 0x0803C1B4, data-base: 0x02005000
cisco 1601 (68360) processor (revision C) with 3584K/512K bytes of memory.
Processor board ID 05574641, with hardware revision 00000000
Bridging software.
X.25 software, Version 3.0.0.
1 Ethernet/IEEE 802.3 interface(s)
1 Serial network interface(s)
1 Serial(sync/async) network interface(s)
WIC with 56k 4-wire CSU/DSU
System/IO memory with parity enabled 4096K bytes of DRAM on S
ry disabled)
System running from FLASH
7K bytes of non-volatile configuration memory.
8192K bytes of processor board PCMCIA flash (Read ONLY)
% WARNING - 64k mode will not work in back-to-back DDS.
Press RETURN to get started!