Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

1416 not grabbing firmware update. 1

Status
Not open for further replies.

ipandy

Technical User
Dec 9, 2010
30
US
Installing a brand new 500v2 with Combo6210, VCM32/PRI, UC Module, and Legacy Carrier ATM. This system only has 6 digital phones and 3 are not grabbing the firmware update. When I plugged one of the phones into the port that was not getting the update, it kept lighting up like a Christmas tree and said check sum then just kept flashing. I unplugged that phone, put one of the other phones that didn't receive update and it just says Fri 02:01 00:04. Running a monitor trace now, but any ideas would be great. I have the TFTP pointed to my laptop with Manager. I am in the process of rebooting with manager closed to see if that helps.
 
Each digital port will only upgrade once without a reboot. So, if you upgraded a phone on port one, then plugged another phone into port one it won't upgrade until you reboot it.
 
Also, with a V2 and only 6 phones why not use the sd card to upgrade them as long as you have loaded them properly?
 
It was a rookie mistake, even though I've been doing this since Merlin Legends. Wire issue, lol.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top