12x0 Fiber Trunk Module

[bevcomm]

Hi,

Is there a trick to getting one of these 12x0 modules to work? I have it plugged into the top port (8) of the 6 port fiber expansion card, and programmed that for a trunk module.... but in programming the module says "unequipped" and when I try to access a line, it doesn't work.. it says "not available" or something like that (I am not on site, will be in about 2 hours)

Sorry for the run on sentence

Thanks for your help

 

[curlycord]

Give a little time to register or reboot system.

 

[bevcomm]

I rebooted last night, didn't help.

I left it up and running since about 3am this morning, so hopefully when I get in it works.

 

[hawks]

Did you disable and then re-enable the Module in Maintenace? Also might want to check the Fiber connecting the 2.

 

[bevcomm]

I think its a dead module.

Accessing the lines says "not in service"

I swapped out the fiber, that didn't work either. I'll send it back and see if the new one is any better.

 

[Dasheen]

Was the power LED lit? If not definitely dead if power source is ok.

 

[swfl]

What about the card(s) in the 12x0?

 

[bevcomm]

I swapped the cards, removed all but 1...etc.

The power LED was on.


I have a replacement in stock, I'll go try that one tonight.