Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
1.5Mb PRI 1
- Thread starter DAS1512
- Start date
Build the D-channels under adan in ld 17
declare the loop in ld 17 cequ
build the channels in ld 14
install the card in the proper network slot. Remember that the nt5d is basically like a NET card and gets its loop number from the slot you put it in.
Usually you run the cables to the back plane.
connect from back plane to your smart jack.
enable in ld 60.
declare the loop in ld 17 cequ
build the channels in ld 14
install the card in the proper network slot. Remember that the nt5d is basically like a NET card and gets its loop number from the slot you put it in.
Usually you run the cables to the back plane.
connect from back plane to your smart jack.
enable in ld 60.
- Thread starter
- #3
-
1
- #4
add the loop to the cequ, then the adan.. to dch will prompt for the loop so IF I REMEMBER right, the loop needs to be in place 1st.. if it's the 1st pri in the box, look at your net data and ldn data if it's did,, then the route then the trunks then go to 96 dis msdl x all enl msdl x fdl, then go to 60 and enll x the loop.. your looking for a "23" code to tell you layer one is up, 60 seconds later the d should establish..
if this is the 1st digital loop, go to ld 73 and set the clock source..
your second one should take under 1.5 hours max.. i've added one in under half an hour.. but i'm old
john poole
bellsouth business
columbia,sc
if this is the 1st digital loop, go to ld 73 and set the clock source..
your second one should take under 1.5 hours max.. i've added one in under half an hour.. but i'm old
john poole
bellsouth business
columbia,sc
- Thread starter
- #5
- Status
Similar threads
- Locked
- Question
