Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. sweetdaddyd

    transferspeed from memory to device to low

    I think we need to isolate the different scenarios. It sounds like you're doing backups over the network. Are the filesystem moves on the same system or does it involve nfs? What does iostat and paging look like? Did the network settings change after the upgrade? Is it local SCSI disk or a...
  2. sweetdaddyd

    Loss of console at run level 2

    It sounds like your console is set to an invalid device or a graphical terminal. What do you get with "lscons"? You can try: chcons -a login=enable /dev/tty0 ...won't take effect until after a reboot.
  3. sweetdaddyd

    ethernet help

    Are you using Jumbo Frames on your Gig-E? Also, you'll probably set the MTU and xmit queue size on your interface. Here's the commands: "ifconfig en0 detach" (assuming en0 is the interface you want to change. You must take down the interface in order to adjust the nic settings - make sure...
  4. sweetdaddyd

    problem booting from cd

    Do you get the LED 185 when attempting to boot from the disk with the CD disconnected? If no, then the CD may not accept the generic cd driver or its causing trouble on the bus. What LED's do you get while booting from Disk?
  5. sweetdaddyd

    problem booting from cd

    How f'd up is your current environment? If you attempt to boot from disk, without the CDROM attached, does it crash with LED185? Do you have a tape drive? mksysb's? Another aix box?
  6. sweetdaddyd

    VIO and AIX 5.3

    Is this thread still active. I have a p550 with 2VIO's supporting 3 lpars with all virtual IO. I haven't implemented any HBA's yet, all internal disk, but the HBA's are next (EMC...). This configuration isn't production ready, wouldn't trust it yet, but it sure is great for putting up...

Part and Inventory Search

Back
Top