Search results for query: *

I found out why the *72 wasn't working. For some reason the phone system isn't sending the * through to the telco. I set the allow list to allow *72 and *73, and set the operator extension in the allowto list, but it didn't fix the problem. We also cannot use *82 to unblock our outgoing number...

I honestly can't remember if it was setup as a PRI or as a plain T1. We had quite a few problems getting the phone system to even see the circuit. My guess is that it was setup as a PRI since the ISP actually did the programming on the phone system for the circuit since the support person for...

I'm pretty sure it's setup with out T1 provider, because at one of the other locations, which has a Toshiba system, they can forward the lines fine there. The support guy for the system said they have to hit #2 to grab the main line (BTN I think is what he called it) for it to actually forward...

We've just recently installed a Merlin Legend system at one of our locations and had the service switched to a T1 from analog trunks feeding an old System 25. We have 40 or so DID's and 1 main number. With the old system we would dial *72 to call forward all calls coming in on the main number to...

I don't think it has that capability, I know that it is not hooked up to a computer. I have looked through the manuals for the phone system but it doesn't explain how to set something like this up.

Sorry for the delay, I have checked the voicemail and it is a Merlin Mail Release 3. There are two boards other boards in the setup one says "Processor W/CKE5" and the other one says "016 MLX". If any more info is needed just tell me what it is that you need and where to find it (I don't know...

TouchToneTommy : The mailbox is set to the largest capacity, but we do not have a full time person to answer the phones at the location(Health Clinic), so the mailbox will fill up with messages after about 5 hours. From what I have been told so far is that it was setup to do a rollover...

I have a Merlin Legend system here and I am trying to figure out how to setup the main switchboard/operators mailbox(100) so that once it fills with messages instead of saying to the clients that the mailbox is full, it will rollover to another mailbox(999). I tried to contact our support vendor...