sh version will give you an easier output to read id you have multiple interfaces. I have 6 and it makes it much easier than scrolling thru all of them.
The first thing I would do is change your traffic shaping to read slightly less than the settings on the telco switch. Probably 750 750 100 and see if you are still getting dropped packets.
You can get all kinds of weird errors when throwing too many cells at the carrier. Been doing frame/atm...
Just as a heads up, I replaced the motherboard and used all the existing hardware and the NM-4A/S module works great. So the motherboard was the culprit.
Thanks for your help IPKONFIG!!
Thats what I was afraid of. I changed everything including the memory. Everything except the main board, so that has to be it. I just built this lab for home and I was hoping to use the 2610 with the 4 port nm module as my frame switch. Not really necessary since I work with Frame Relay and ATM...
Unfortunately I have no other modules that will fit that slot. I did take out the T1 WIC to make sure I wasn't getting some sort of conflict but I am still getting the following error:
System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)
Copyright (c) 1999 by cisco Systems, Inc...
Yes, I forgot to mention, I put the Module in another 2600 with the same IOS and memory and it worked fine. Sorry for leaving out that important peice of info. Brain is a little fried from working on it so late last night.
Hi all,
I have a cisco 2610 with IOS 12.3(10) with 1 T1 CSU/DSU and 64M Dram and 16M flash. I just bought a NM-4A/S module. Everything works fine on the router until I add the new module. Once I instal it and reboot I get the **PCI Exception Error** with some numbers below it. I will post the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.