Search results for query: *

from load 22 >prt >pwd you can see a lock associated with a login ID. That is what I'm hoping to clear.

The timeout idea works fine, but I suspect what's happening is OTM is continually trying to login with the wrong password. Hence I would like to remove the lock manually. Done it before, just can't find it now.

Clarification - it is the Login ID that locks out. Can anyone help with an unlock command?

Thanks, but it's the login that's locked, not the port. "set lock 0" or something like that from what I remember, but I need the load.

Hi, Can someone tell me how to remove the lock on a tty port? I'm troubleshooting some OTM issues and suspect I keep locking all the PTY ports and want to ensure they aren't locked. Thanks, Fred

I need a "dry pair" between two sites (15 miles apart) that only have the T1 between them. The pair will be used for a Motorola Spectra TAC Comparator. It selects the best radio signal to use when transmitting between the sites. The line can be a "Type 5" or "3002", (no dialtone). All comments...

Hello, has anyone configured a 2-wire circuit (for alarms) between an 11c and a mini-carrier remote (connected by T1)? The main cabinet has both Analog and Universal trunk cards. The mini-carrier only has a Universal trunk card. Thanks, Fred

Hello, Can anyone tell me if it is possible to have Meridian Mail (rlse 13) send an email notification when a message is left in a mailbox. I have an 11c (rlse 25.30). All comments appreciated.

Haven't had any success entering multiple DNs or putting the number as an extension... but perhaps there is a magic seperator that I'm not aware of?

Can anyone provide a way to light the message waiting indicator on multiple sets (3903s & 3904s) when a message is left in one mailbox? I've tried using a distribution list (no lights). I have an 11c (rel. 25.30) and full Meridian Mail (rel. 13) Thanks.

Thanks for the feedback, I've confirmed with MCI that the correct setting is NI2 and could have used FDL rather than popping the card (doop). I'm now waiting for my next change window to change the PIN from 1 to 4 to see if that clears up the signaling.

Hello, I'm trying to resolve a problem with outbound caller ID. I suspected the problem was that my 11c (Rel. 25.30) PRI wasn't configured properly for MCI's switch. My current PRI config lists the IFC as NI2 and RCAP as COLP ND2. MCI's tech says I'm connected to an ESS5 switch, yet when I...

I'm having this problem as well. Only it doesn't happen to all PCs, and the ones that it does happen on work fine after "ANY" change to the configuration is made... for about an hour. Then they're back to taking over a minute to open office documents. Any thoughts would be welcome.

Hi All, I've got problems getting my outbound caller ID to pass through restricted sets: "..caller does not accept unidentified calls". I suspect my 11c isn't talking correctly to the switch on the other side of my PRI line. My IFC is set to NI2.? In conversation with my vendor (MCI) they...

Has anyone had any success in sending an ITG card in for repair? (or any other 11c cards for that matter). The best replacement price I've found is $2000 :-(

Yes, Ipeology, both ports are dead.

Hello, I've just tried to put an older, trunk side ITG card back into service and found it won't put-out, literally. I get absolutely nothing on the maintenance port during a boot and it won't respond to any of the alternate boot commands (+++ etc). I've carded the battery and gone as far as...