Search results for query: *

Hi, i have 3825-Cisco router connected to a layer 2 link going to a remote site and cisco-4503 core switch as my distribution switch. my question how would i enable/configure the auto-qos in my cisco router and core switch for my avaya system. i have two Voip traffic in my network the IP...

Hi Guys, i have activated my dcs feature in my IP trunk on a S8710 server with CM3.0 same with the other server. on calls i have problem.. it will display the name but the extension it will display only the first 5 digit not all the seven digits e.g. 48100 supposed to be 4810000. do miss...

Hi Everyone, how do i able to check if EMMC server properly started it's internal application process after a longer power down, what linux command do usually issued to EMMC server if needs a start up. i've tried the reset button but no luck. we are using S8500B CM3.0 with EMMC ver 1.0.17 "We...

yes i am G.711A exactly. do i need a separate SES server for the SIP trunk?

i've tested five extension today with same result 1191 network failure is indicated on the trace.

Hi Everyone, we had a Avaya S8500B EMMC server connected to a clan this was working last week, when i made a testcall it give me a busy tone but the signaling and SIP trunk are in service. for the trace i see 1191 error it said network failure. any ideas y this happening? thanks n advance,

list trace find no error, i see a sucessfull call.

Hi All, i have 5 analog and digital phones under cor 20 with Outgoing Trunk Disconnect Timer (minutes):2 activated but the timer will not cut if these telephones tried to call outside. my trunk is ISDN 30 channel thanks

Hi does anyone have an idea if i could back-up witness by monthly basis? Thanks

Hi All, does anyone here having this issue. I'm having problem with my Avaya IA770 INTUITY AUDIX. we cannot leave message to a station it will always say NO NAME RECORDED after pressing # sign!, when i checked the greeting recording it will say NOTHING TO APPROVED!. this was working before, i...

i have already the account for it. thanks ronster avaya told me they will e-mail the patch.

thanks ronster for your reply i have a test server standing by with CM 5.0 on it.

Hi Mikey, we resolve the issue it's in the co trunk configuration the IT guy enabled the auth code. thanks, kabudoy

Hi Everyone, does anyone have this patch for CM 5.0 00.0.825.4-15759 (SP3). i'm in need this patch for my S8300 server. Thanks in advance, Kabudoy

Hi All, may incoming call suddenly crash out when i list trace it it shows - denial event 1641: Permanent seizure D1=0x830001 D2=0x80 - when to dialed from my celphone it gives me two rings then a long tone, my outgoing is working fine. my trunk is a co type loop-start it working for the two...

Hi All, I'm using 4600 series as an alias to my 1600 series phone. i have issue with the message button it doesn't work i already load the 46xxsettings.txt file and change the 9600 series MSGNUM XXXX since i dont see the 1600 series for MSGNUM XXXX. my current load on tftp: ha1608ual_010.bin...

Thanks guys for support will have it rectified.

we don't use DHCP, ip phone configured as static

As per network team switch port conected to the LSP sever is Auto not 100 full duplex.

IP phone is using static IP address