Search results for query: *

Switch#show interface FastEthernet 0/24 FastEthernet0/24 is up, line protocol is up Hardware is Fast Ethernet, address is 0050.d1dd.9958 (bia 0050.d1dd.9958) MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec, rely 255/255, load 1/255 Encapsulation ARPA, loopback not set, keepalive not set...

Setting the speed/duplex on port 0/24 and my nic and insuring that they matched didn't help. ! interface FastEthernet0/24 speed 100 duplex full ! Also my config above wasn't copy/pasted correctly: here it is again: ! interface VLAN1 ip address 192.168.1.9 255.255.255.0 no ip route-cache !

Oh and when I said I have been reading everything; that includes reading every post in this forum. So if I missed a post that previously covered this in my search; I apologize and would appreciate a link to that post.

I just inherited a Catalyst 2900 (24 port) switch (model WS-C2924) and I have never before used any Cisco gear (only HP and 3COM). The problem is that I can't get this switch to communicate to any Ethernet devices. I would greatly appreciate it if you could point in a direction that will help...

Thanks. The link was very helpful.

How do I pass a non-zero return code from a COBOL program to the JCL job step that executes it. Or in other words force a job step that executes a COBOL program to end with a specific condition code.