Search results for query: *

Hi there, I'm having some hard time configuring transparent web proxy on a pix. i have one interface as the dmz. thats where my web proxy is. and i want all the traffic which will be port 80 on the inside lan to go through it. my proxy server has 10.1.1.10 my inside lan has 10.1.0.0/24 my dmz...

i am having the same problem did you find a solution yet

how do I map the x25 to the dialer interface and configure a CUD (Caller User DATA) on it thx

Hi KY, thx for your reply, in my case i dont have a TCP/IP net, i have to dial out over the PSTN / ISDN and over ISDN there will be x25 running, my problem is i dont know the ip address of the remote device in order to map the x121 address to a Layer3 address. DO i neccessarily need a L3...

hi , another Q: if i want to configure my router to make an outgoing call , not with 0 as prefix, rather with a 6 as prefix. cheers

Hi folks, I have a Server which i used for isdn/x25 connection to my local provider. now i want to substitue my server with a router. what i need to know therefore is , how on earth am i going to make a X25 over isdn connection, when the X25- ISP-machine I'm authenticated before doesn't have an...

Hi there, and again an impossible task. I have a scenario where i use a callmanager on one side and a pbx o the other, in between there is a dedicated 2 mbit link. now i can use a gatekeeper for this, right? and also, if I'd like to limit the actual calls at a time to 4, where and how do i...

Well, there is a need for security, so therefore ipsec. but is it possible to use ipsec over a bridging router ? i gave my BVi intf an ip addr. and my other ports LAN (e0)and WAN (s0) were in the bridge-group. Can I run IPSEC over it? what do i specify as the peering partner, the other BVi...

hi there, i have two sites which are connected via wlan bridges. now i want to encrypt them, so i installed two ios-routers on each side. i have to bridge the router (yes brdging not routing) because of several reasons. now i would like to make my wlan conn a little bit safer and therefore...

Hi, two things : 1) if you use deny icmp any any then you will sooner or later turn into problems for your path-mtu-discovery, rather let a few icmp codes through and deny the rest of the icmp traffic, here is an example how: access-list 101 permit icmp any any echo-reply access-list 101...

Hi Folks , I have a question about VPN/IPSec passthrough. My company has a firewall with private ip addresses on both interfaces and as a border router a cisco machine which is doing nat. on the other site there is the same constellation. now we need to get ipsec traffic which is terminating on...