Search results for query: *

Hi, i will try to keep this as consice as possible: I have two sites connected via a point to point T1 and Nortel Contivity's on each end. The WAN address of Site a is 192.168.0.1/24 and the WAN address of site B is 192.168.0.2/24. From Site A, I can see site B's WAN interface fine. I can...

I tried that. It continues to boot into ROMmon mode after displaying the magic number error. After doing some reading on cisco.com everything is pointing at the NVRAM chip being corrupted. Any one have this happen before?

I am having the no magic number error problem with my 2611XM: loadprog: bad file magic number: 0x0 boot: cannot load "flash:" I have an IOS image in the dir flash:. I can issue the boot c2600-ipvoice-mz blah blah blah command and it loads the IOS fine. I can dump my config into the...

I am having this same problem with a 2611XM. Only difference is that I have an IOS imagine in the dir flash:. I can issue the boot c2600-ipvoice-mz blah blah blah command and it loads the IOS fine. I can dump my config into the router fine and it works. I can write the config as well. When I...

Im a layer 2 tech getting my feet wet with Cisco IOS etc...Im attempting to set this router up at my desk so I can have a hands on kind of environment to mess with. I didnt read anyhting anywhere about this kind of thing causing the network as a whole any problems. No different than a host...

Maybe I should have clarified my environment. I connected my router to my network at work which is a class B network and created my own class C network on the inside of that router. So really I am trying to find my way out ot the internet though the class B network. I changed the routing and...

Hi, Im a new to setting up Cisco routers. I have set up a 1721 to act as a dhcp server and to perform NAT. The config is as follows: Current configuration : 1509 bytes ! ! Last configuration change at 08:22:15 UTC Tue Sep 21 2004 ! NVRAM config last updated at 06:31:53 UTC Tue Sep 21 2004...

I am currently running a Nortel Merdian Option 81c and I am having trouble in restricting 500 sets to only be able to dial local and toll free calls -- no long distance. I am unable to find the middle ground in Class of Service which will allow me to restrict Long Distance calls and allow these...