Search results for query: *

I've read all the posts here and have a question. I have window 2003 small business server. Loaded PT 2004. It runs fine for the administrator account (account used to install it. I have Terminal Server installed in application mode and use the remote desktop application to connect to the...

I'm trying to uninstall Frontpage 2K off a Win2K Terminal Server. I've tried uninstalling from add/remove programs, but I get the error: "Some default settings in Fronpage 2000 setup do not work properly on a Windows Terminal Server. You must use the instructions and tools available in...

Thanks guys, i'll give it a shot.

the access list 100 is allowing everything through the f0 port, i'm blocking everything at s0. so, i should open up icmp at s0. it'll only be temporary, don't want to leave it open.

What do I need to do to allow tracert and ping requests through my cisco 1721. Here is my running config. I'm sure it's something easy. Cisco1721#sh run Building configuration... Current configuration : 4765 bytes ! version 12.2 service timestamps debug uptime service timestamps log uptime...

Hey guys, I was just wondering if there is any settings on the cisco router that might be causing ftp connections to time out. I have client that continues to time out while transferring files and I need to ensure it's not my the 1710 routerI put in place, which seemed to happen about the same...

How do you disable ip inspect of smtp traffic. I can't figure out the syntax of the command. Any help would be appreciated.

I figured out how to add the nat mapping to s0. After adding port 21, ftp worked, oversite on my part.

The two port 25's are correct but you are right that I don't have any port 21 translations. How do I add a static nat, I used configmaker for the original config and haven't found any info on how to add a nat static command to the pool.

The error message I get now is "A socket operation was attempted to an unreachable network" using Smart FTP. Here is my Config... I have my ACL on my incoming side of S0. Cisco1721#sh run Building configuration... Current configuration : 4657 bytes ! version 12.2 service timestamps...

Hey guys, I'm trying to ftp into my webserver. For some reason it's not working. I've read other forums and have tried there suggestions and nothing seems to work. I permit ports 20-21. And I have the line "permit tcp any host X.X.X.X gt 1023 established in my acl". I'm also...

Thanks, The speed command worked.

I went through the steps of installing a new IOS on my 1721. Changed the baud rate to 115200 as instructed, to use xmodem. I've tried changing the settings back to 9600 using rom monitor and confreg. But when I reset, it boots using 9600, I can see the boot processes, but then changes to...