This is the configuration of my interfaces
!
interface GigabitEthernet4/3
description Enlace de Cobre 8vo Nivel
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 1,108,192
switchport mode trunk
channel-group 8 mode on
!
interface GigabitEthernet4/6
description Enlace de...
Hello all. I was just wondering I was looking at the configuration of portchannels when I notice that there are two ways of creating a portchannel a layer 3 and a layer 2 portchannel as you all can see in my configuration I have a layer 2 portchannel and the ip address is asigned in the vlan...
Hello all. I have a cisco 2950G switch, all my software development departament is connected to it. they have several telnet and ORACLE connections to my servers. the problems is that in some point it seems to flush all the network connections. All computers are disconnected from the Application...
Hello All. I have a Cisco 2950G switch, with ios:
C2950 Software (C2950-I6Q4L2-M), Version 12.1(9)EA1, RELEASE SOFTWARE
I have to upgrade all my switches to the newer version, the thing is that I don't know how and what file should I choose, that's because I have found several versions of...
Hello all! I'm have a Windows XP PC with 2 NIC cards each one connected to VLAN 192 and the other connected to VLAN 1. Each VLAN has a different IP Address subnet
VLAN 192: 192.168.12.2
interface FastEthernet0/23
switchport access vlan 192
switchport mode access
no ip address
end
VLAN 1...
Hello all, I have a switch configure with vlan trunking so I can pass traffic of two vlans(1,8) I configured some ports to vlan 1 and others to vlan 8. It work fine with all the other vlans in the network except for communicating with each other. I can reach all the host in the other vlans but I...
Hello all, I want to buy a cisco router for the simple purpose to balance my two ISPs internet connection and then enter in a PIX 515 FireWall. AFAIK I have to use a router that supports BGP. I have seen the 830 model, but what is the model you guys advice to buy?
thanks in advance
this is the way I have my interfaces configure for vlan trunking
interface GigabitEthernet1/1
switchport
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 1,103
switchport mode trunk
this configuration has to be in both ends of the connection
for example if I connect this...
Hello all I hava a 4506 as a core switch with 8 switches and 8 vlans, I set the 4506 DHCP Server to give 172.16.101.X addresses to Vlan1,172.16.102.X to Vlan2 and so on. The problem is that I need in some switches to have and interface with the ip address 172.16.1.X in Vlan2 for example.
My...
no it just freeze, and no response at all. I try to reconnect to the console and get no response. I just hangs. The switch works fine, and telnet sessions work for a while and later the same thing.
thanks in advance
Hello all. I'm having big troubles trying to get this work. I have a catalyst 4506 switch. Since I connect all my network to it, I can have access to the console, it does not respond to anything until y reboot the switch, but when I try to "sh run" or "wri mem" the console...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.