Search results for query: *

How do I code a static route to be less preferred than an OSPF route? I've used the COST parameter in the static route command and made it greater than the OSPF cost but when I remove the existing route (learned by BGP) the static route takes it place. I want the OSPF route form an adjacent...

I need to config a Cisco 2600 router to use ISDN as a dial backup to a frame relay circuit. The Cisco will be dialing a Nortel BCN. Does anyone have a sample config that I can use. The Nortel is configured to accept specific chap info from the site. How do I include that in the Cisco config.

I tried the ping command without success which led me to issue the test command.

Can someone please confirm that this is a hardware problem. I cannot ping the interface locally. The weird thing is that I can ping it remotely. Does someone have an explanation for that. test interface fast 0 ... Failed - timeout problem 1 interfaces: 0 passed, 1 failed, 0 skipped, 0...

Can two ports be mirrored on a baystack 350 10/100 switch? I'm following the port mirroring instructions but I can't seem to make it work. Does the switch need to be on a specific release? Jack.

I have two BCN's in an OSPF area. I'm trying to clear bogus ospf routes. The clear ip routes command does not work for ospf routes. Is it allowed? I'm running 15.1.0.0. I think I hit an OSPF bug because my routing table went from 900(normal) to 1300. The difference being 32 bit mask ospf routes...

I downloaded 3.5.3.0 and upgraded both cps's. Upgrade was successfull but with incidents. The rwa password became corrupt on the backup cpu and i had to boot in monitor mode and reset-passwd back to default. I did not run into this problem when I upgraded the second cpu. I also had one GIG port...

I've upgraded the memory to 256MB as required. The error is happening on both CPU's. One Nortel tech says I should upgrade each blade individually while the other is pulled out. Another tech gives me Nortel instructions to upgrade the backup cpu first and them the primary. I know that different...

I am upgrading from rel 3.0.4 to 3.5 and get the following error Loading /flash/p80a3500.img ... 5124005 to 18290148 (18290758)gzclose errno 0xff fffff9 file crc error S_iosLib_INVALID_FILE_DESCRIPTOR Nortel says its a corrupted image. I sent the image I used to them and it loaded...