Hello,
I was wondering if anybody has used the JetStor SCSI attached devices with pSeries. In particular we are trying to hook up a JetStor 416S to a p570 and want to know which HBA's have worked successfully. Thanks very much in advance.
Mike
Hi Paolo,
Nevermind, Please disregard my last post. That was a stupid question. You will not be able to run the lsvg command since the volume group is not varied on.
You should be able to see what disks the odm thinks are in that volume group though by excecuting this command:
odmget CuAt...
I was looking at the configuration script that the controller creates when you use the save configuration option. It does have a section to recreate all of the mappings. I don't have a controller to test it on though. Thanks for your response.
Hello ALL,
I'm wondering if anybody has had any experience replacing a ds4300 (or similar) with a ds4800. I have 5 arrays spread across three exp710 drawers. We are going to install a ds4800 and attach the drawers to the new controller. I know the array and lun information would reside on the...
We were just trying to get the host port to log into the fibre switch. We'll see if we can connect directly to a host though. We have tried everything else at this point. The drive might be there today and we can clear the error condition and then see if the port will log into the switch...
Hello All,
I have an odd ds4800 problem. I am trying to connect one of the host ports on the 4800 to a Brocade switch. I get the port to log into the switch with it's wwn. I get a link on the switch but the ds4800 says that the host port on the controller is down.
Here is what I've done...
I have been asked to do some research on the feasibility of setting up an Apple XserveRAID connected to an RS/6000 through a Brocade 3200 fiber switch. I have been searching for some case studies on the web but have not found anything specific yet. Does anybody have any experience with a...
It seems to have corrected itslef. I ran a backup with that save set removed from the client resource and the backup ran fine for all of the save sets. Then I added that save set back to the client resource and it did an incremental just as it was supposed to do. I suspect that you were...
Hello all. I have a rather large file system, about 800GB, that I have been doing incremental backups on just fine. I decided to do a full backup over the holidays while things were slow so that I could have a copy of the save set. The full backup completed and then immediately said that...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.