Search results for query: *

Well,PCM-link through ATM switch i have done it. Still is via IP but is a permenant connection with configure by the ATM switch supplier.On MD side the GJUL and GJUG both are connected to the E1 card at the ATM swtich.

better way is to restric from the traffic matrix. is very easy. just need to make sure that the traffic matrix is just for incoming.

You can refer to the 1 of the tread there, limbabwe is telling people how to erase the eic and write again. It is tested can be done.

you are welcome

what version of software for the pabx? do you program ODN2?

what the parameter you using for route and extension?

if the license is written before in the NIU the you will not be able to rewrite. The EIC will only can write one time.

How about the syn cable connection? do the ELU 31 all connected with the syn cable?

ask the switch to check on their line..there are no signal to indicated the trunk is seize.surely will be the seting on the AXE.

my office have 1 and it quite reliable.of cos all of this is just estimation..so no 100 accurate.

you can request the patch from ericsson itself.

actually that is the optional thing. there are a O&R patch for that..you can't just change that as what you want and will not be able to see that.

well,actually the DPM is the traffic measurement from MD. Just the same as we using command to initiate for traffic measurement and print it out.the different is just DPM can put it into graph or chart.so it should be trustable

then you can just used E&M tie line,and more easy for test.

You can used E&M tie line or Q-sig tie line to tie with the cisco at both side.this should work and cisco router should be able to provide this.

if both of your incoming line connected to public exchange then you can't do anything about that..if 1 from public exchange and 1 for your private network then you can do as what i show you on above.That already tested on my LAB and working fine. private network mean that the Q-sig which...

sorry, i don't think it works.this will make the md to send 27755xxxx,still need to use nutri:entry=xxxx,trc=1,numtyp=11,cnvtyp=1,trc=1;

you can try this, rondi:rou=xx,exnopr=5-27755 see what will happen.if not mistaken md will sent the number 27755 to you private network.and check on your extension adc value.try to put the adc on your extension open to send a-numer for analogue extension the adc last digit open to 1 and for...

which commands you want?

by phone will be the easy way.you can by just pressing the button of program then with the buttom of access1 (if you want to change CALALT on the ODN),mdn & adn,and press the CALALT number you want it to be. Via fiol you need to cancel the number and program it back with an additional parameter...