Thanks for helping me last night. I really appreciate. There were wiring issues I discoverd at the end also. The telco hooked line 3 in position 3 and not 5 as the cable required.
Thanks again
Thanks a lot. If I call it now it does ring and I can answer.
If I tie up the other 2 numbers then it will not ring in the office, what did I do wrong?
Thanks for your patience.
Thanks for being so patient, I really am sounding like an idiot, Now I know how users feel to asking why turning off their computer by pulling the power plug is bad.
I am at the
Proceed to the next station and repeat step.
The console shows
L003:Appr&Ring
SCAN FIND CHANGE
Do I hit the Next...
Do not know how to call out on that line without a button to push, boy, I bet that sounds really dumb too. The line does work as I tested it at the dmark and got dial tone. Had to go back and get the manuals, I am on the way there now, thanks for your answer. Two phones can call out at one time...
Newbie setting up CICS with 3 phone lines and 10 m7310 phones.
Telco hooked up their stuff and I have a cable that goes from the telco block into the CICS. Did default "square" install. First two telephone numbers work fine.
The third number just rings and rings but phones do not...
Excuse my stupidity, just now having to learn this stuff, normally I am a Network Geek. I have a Nortel Meridan 6x16 but am short some phones for it. Will a NT4X37 otherwise known as a MERIDIAN M5312 work with it? I currently have some M208s and a single M7310. Any help will be appreciated.
BTW...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.