Search results for query: *

How can I include a file in a tex document that has an underscore in the filename. ???? ie.. for the following include lit_review.tex I get an error saying the file can be found, but if I include a file include intro.tex it works

Does the field sk_buff->len contain the size of just the ethernet payload, when a packet is being transmitted and received?

I figured it out already. But thanks anyway. I assigned vlan0 to tag 8 and ip address 192.168.8.254/29 The other address 192.168.8.246/29 is added as an alias to the vlan interface.

I have two subnets within a vlan. e.g. # The network addresses are 192.168.8.240 and 192.168.8.248 The network mask is 255.255.255.248 (ie 29 bits used for network address) Both of these networks are tagged with the tag 8 by the switch. I have a single interface I want to be on both networks...

I have a linux based router. (standard pc hardware with 2 NICs). I want to be able to graph the rate of data that passes through each network interface over a short period of about 5-10 mins. I would need to find out the rate of data passing through the network interfaces every 10 seconds or so...

I have a laptop with the following Fast IR (Infrared): sensor compatible with IrDA Standard 1.1 (Fast IR) and IrDA Standard 1.0 (Slow IR) is it possible to get a normal television remote control to talk to the irda receiver on the laptop ?

I just replaced the cmos battery with a lithium CR 2032 sv. Pc still wont boot. There is a single short beep just as i turn the power on the pc. The keyboard doesnt seem to be getting any power.

Pc is a compaq deskpro ep series (not homebuilt) p3 500

The cmos battery is just under the Nic I inerted. See picture. It is possible that it could have moved when i was putting in the NIC and taking it out. http://frink.nuigalway.ie/~jlynch/motherboard.jpg I tried clearing the cmos by powering off and moving the jumpers on the board. How do i...

still the same result...wont boot

I was inserting a network card on my pc and was rebooting a few times. The last time the computer booted, the bios gave an error that the time and date were not set. I had noticed previously that the time in the bios was slow by 10 minutes. The next boot, nothing shows up on screen. Computer...

Im using both win xp and fedora core 2. Ya I checked bios setup. I have both channels enabled in the bios. Havnt tried reflashing the bios to a lower version yet. This is the bios version I upgraded to...

Ever since I flashed my bios to the newest version nothing gets picked up on the secondary IDE channel. I have tried different ide cables. Different humper settings. ie setting the hard disk I wasnt to get picked up as both master and slave on the secondary channel. Unknown device comes up in...

Flashed the bios successfully. Thanks to everyone for their help. Another question The motherboard only supports ATA-33. The hard drive with the OS has a spindle speen of 5,400 rpm Would using a hard drive with a spingle speed of 7,200 rpm improve performance on this pc ?

Changed the order of the ram modules and now all of the ram is detected by the Bios....384mb

I have only 3 slots for memory. The maximum it can take is 3x256mb = 768mb. I will experiment with the ordering tonite and see if it makes any difference. The graphics card is a 32mb Creative Savage 4.

no... Motherboard is EliteGroup P6BX-A With Award Bios version 4.51 PG dated 01/19/1999 I am also trying to update the bios as well. Im not sure whether the first one on the following page is the right one...

I have 3 memory slots which are filled with 64mb, 64mb and 256mb SDRAM modules. This should give me 384mb of ram but only 320mb of it is picked up. Anyone have any ideas why. Output from the Cpu-Z utility which gives more detail as to the type of ram and the Memory SPD...

Im am currently running XP service pack 1 on a 20gb drive. I want to set up my 250GB drive as the master and run the Operating system off it.

on the dell website they have the bios upgrade but its seems as old as the version thats on it already BIOS: Dell Dimension System BIOS, English, Dimension 8100, A06 Dimension 8100 A06 FlashBIOS File Name(s): 8100_A06.EXE,B8100_06.exe File Date: 01/05/2001 File Size: 474112 bytes Downloads: 0